The Goodyear Tire & Rubber Company – Fayetteville Plant

MACT Subpart XXXX Condition – Permit T31

5. 40 CFR 63, Subpart XXXX - Rubber Tire Manufacturing:

a. Emissions of each HAP listed below shall not exceed 2 pounds per ton (lb/ton) of total cements and solvents used at the tire production affected source, as it is defined in 40 CFR 63.5982(b)(1):

HAP Name CAS No.

Formaldehyde 50000

Ethyl carbamate (Urethane) 51796

2-Acetylaminofluorene 53963

Carbon tetrachloride 56235

1,1-Dimethyl hydrazine 57147

beta-Propiolactone 57578

Lindane (all isomers) 58899

N-Nitrosomorpholine 59892

Dimethyl aminoazobenzene 60117

N-Nitrosodimethylamine 62759

Diethyl sulfate 64675

Chloroform 67663

Hexachloroethane 67721

Benzene (including benzene from gasoline) 71432

Vinyl chloride 75014

Acetaldehyde 75070

Methylene chloride (Dichloromethane) 75092

Ethylene oxide 75218

1,2-Propylenimine (2-Methyl aziridine) 75558

Propylene oxide 75569

Dimethyl sulfate 77781

Acrylamide 79061

Dimethyl carbamoyl chloride 79447

2-Nitropropane 79469

2,4,6-Trichlorophenol 88062

3,3-Dichlorobenzidene 91941

4-Aminobiphenyl 92671

Benzidine 92875

o-Toluidine 95534

2,4-Toluene diamine 95807

1,2-Dibromo-3-chloropropane 96128

Ethylene thiourea 96457

Benzotrichloride 98077

4,4-Methylene bis(2-chloroaniline) 101144

4,4-Methylenedianiline 101779

1,4-Dichlorobenzene(p) 106467

Epichlorohydrin (l-Chloro-2,3-epoxypropane) 106898

Ethylene dibromide (Dibromoethane) 106934

1,3-Butadiene 106990

Ethylene dichloride (1,2-Dichloroethane) 107062

Acrylonitrile 107131

Chloromethyl methyl ether 107302

Bis(2-ethylhexyl)phthalate (DEHP) 117817

Hexachlorobenzene 118741

3,3-Dimethoxybenzidine 119904

3,3-Dimethyl benzidine 119937

1,2-Diphenylhydrazine 122667

1,4-Dioxane (1,4-Diethyleneoxide) 123911

Tetrachloroethylene (Perchloroethylene) 127184

Ethyl acrylate 140885

Hydrazine 302012

1,3-Dichloropropene 542756

b. Emissions of each HAP not listed in Section 2.2 A. 5. a. of this permit must not exceed 20 pounds per ton (lb/ton) of total cements and solvents used at the tire production affected source.

c. Pursuant to 40 CFR 63.5985 (“Purchase Alternative”), the Permittee shall only use cements and solvents that, as purchased, contain no more HAP than allowed in Section 2.2. 5.a. or b. of this permit.

Monitoring/Recordkeeping [40 CFR 63.5994(a)-(b)(1), §63.6003(a), §63.6004(a), §63.6004(c)]

d. The Permittee shall maintain the following records:

i. An updated list of each cement and solvent as purchased and the manufacturer or supplier of each;

ii. A record of the concentration of each HAP in each affected solvent and cement. The HAP concentration shall be determined using EPA Method 311 (40 CFR 63, Appendix A) or an alternative approved method, including but not limited to obtaining appropriate Material Safety Data Sheets (MSDS).

In accordance with 40 CFR  63.10(b)(10), all records shall be maintained for a period of five years and, at a minimum, the most recent two years of data shall be retained on-site. If the above records are not retained, or if the HAP concentration of any solvent or cement exceeds a limit pursuant to Section 2.2. A.5.a. or b., the Permittee shall be deemed in noncompliance with 15A NCAC 2D .1111.

Reporting [40 CFR 63.6004(b), §63.6004(c)(3), §63.6010(c), §63.6010(f)]

e. The Permittee shall submit an annual summary report, acceptable to the Regional Air Quality Supervisor, of monitoring and recordkeeping activities postmarked on or before January 30 for the preceding calendar year. The report shall include the following information:

i. Identification that the Permittee has chosen the “HAP Constituent” emission limit option pursuant to 40 CFR 63.5984;

ii. Identification that the Permittee has chosen the “Purchase Alternative” compliance option pursuant to 40 CFR 53.5985(a);

iii. Identification of each new cement and solvent used at the facility that was not previously identified on the list of affected materials;

iv. A statement certifying that, as purchased, each cement and solvent used at the facility during the reporting period met the emission limits in Section 2.2. A.5. a. and b. of this permit.

v. Identification of any deviation from the emissions limitations in Section 2.2. A.5. a. or b. of this permit;

vi. If there were no deviations from the emissions limitations in Section 2.2. A.5. a. or b. of this permit, include a statement to that effect; and,

vii. Statement by a Responsible Official, with that official’s name, title, and signature certifying the accuracy of the content of the report.